Installation Procedure
WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Install the vertical actuator (1, 4) to the upper channel (3).CAUTION: Refer to FASTENER NOTICE in Cautions and Notices.
- Install the actuator nut (2) to the upper channel (3).
Tighten
Tighten the nut to 5 N.m (44 lb in).
- Install the motor support bracket, if previously removed. Refer to Seat Adjuster Motor Replacement - Front .
- To install the vertical actuators bolts (5, 9), perform the following steps:
- 4.1. Using the power seat switch place the seat adjuster in the full forward position.
Install the rear actuator bolts (9).
Tighten
Tighten the bolts to 4 N.m (35 lb in).
- 4.2. Using the power seat switch place the seat adjuster in the full rearward position.
Install the front actuator bolts (5).
Tighten
Tighten the bolts to 4 N.m (35 lb in).
- 4.3. Disconnect the electrical connector for the power seat wire harness.
- 4.4. Remove the adjuster assembly from the vehicle.
- 4.1. Using the power seat switch place the seat adjuster in the full forward position.
- Connect the drive cable to the actuator (1, 4).
- Push connector for the drive cables into the actuators until a loud audible click is heard.
- Remove the protective barrier from inside the vehicle.
- Install the front seat adjusters as an assembly to the seat cushion frame. Refer to Seat Adjuster Replacement - Front .
- Verify that the adjusters are in phase. Refer to Seat Adjuster Phase Adjustment - Power .