Removal Procedure
WARNING: This page is about a different car, the 2002 GMC Yukon XL, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the valve rocker arms and pushrods. Refer to Valve Rocker Arm and Push Rod Replacement .
- Rotate the crankshaft until both valves are closed before installing the compressed air into the cylinder.
- Remove the spark plug from the cylinder being serviced.
- Remove the valve stem keys as followed:
- Install the J 22794 into the spark plug hole.
- Apply compressed air into the cylinder in order to hold the valves closed.
- Lightly tap the valve spring cap to loosen the valve stem keys.
- Install the J 5892-D to the cylinder head.
- Install the valve rocker arm nut.IMPORTANT: Tighten the valve rocker arm nut enough to hold J 5892-D in place.
- Using J 5892-D compress the valve spring.
- Remove the valve stem keys (1).
- Slowly release the J 5892-D .
- Remove the J 5892-D from the cylinder head.
- Remove the valve spring cap (2) and valve spring (3).
- Remove the valve stem oil seal (4).
IMPORTANT:
Rotate the piston in the cylinder being serviced to the bottom of its stroke, to ensure that the engine does not rotate when the compressed air is applied.
IMPORTANT:
Do not release the compressed air from the cylinder being worked on. The valve will fall into the cylinder bore.