LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 681 (Engine Mechanical - 8.1L (On-Vehicle)) >> Repair Instructions >> Crankshaft Balancer Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 GMC Yukon XL, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Crankshaft Balancer Bolt & Washer
    GM470799Courtesy of GENERAL MOTORS CORP.
  1. Remove the air conditioning (A/C) belt. Refer to Drive Belt Replacement - Air Conditioning .
  2. Remove the fan. Refer to FAN REPLACEMENT in Engine Cooling.
  3. Remove the starter motor. Refer to STARTER in Engine Electrical.
    4. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
    IMPORTANT: Ensure that the teeth of the flywheel holding tool engage the engine flywheel teeth.
  4. Install the J 42847  to the starter bolt holes.

    Tighten:  Tighten the J 42847  bolts to 50 N.m (37 lb ft).

  5. Remove the crankshaft balancer bolt and washer.
    6. Fig 2: J 42846 Installed On Crankshaft End
    GM640013Courtesy of GENERAL MOTORS CORP.
  6. Install the J 42846  onto the end of the crankshaft.
    7. Fig 3: J 34816-B & J 42846 Installed On Crankshaft End
    GM640014Courtesy of GENERAL MOTORS CORP.
  7. Install the J 38416-B  (2) onto the J 42846  (1) in order to remove the crankshaft balancer. Place the legs of the J 38416-B  into the recesses cast into the backside of the balancer inner hub.
  8. Tighten the center screw of the J 38416-B  until the crankshaft balancer is clear of the crankshaft nose.
    9. Fig 4: Crankshaft Balancer
    GM640015Courtesy of GENERAL MOTORS CORP.
  9. Remove the crankshaft balancer.
  10. Remove the J 42846  from the end of the crankshaft.
scientia non olet · About LEMON Manuals