Conditions For Running DTC P0752

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, 2002 Chevrolet RV Cutaway, and 2002 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

DTC will run under the following conditions:

No MAP sensor DTCs P0106, P0107 or P0108.
No TP sensor DTCs P0121, P0122, P0123, P1120, P1220 or P1221.
No ISS DTCs P0716 or P0717.
No VSS DTCs P0502 or P0503.
No TFP manual valve position switch DTC P1810.
No TCC PWM solenoid valve DTC P1860.
No TCC DTC P0742.
The system voltage is 10-18 volts.
The engine must be running more than 400 RPM for 7 seconds.
The vehicle speed is greater than 7 MPH.
The throttle angle is greater than 10 percent.
No transmission component slipping DTC P1870.
The engine torque must be between 80 ft. lbs. (108 N.m) and 400 ft. lbs. (542 N.m) on 4.3L and 5.7L models or 650 ft. lbs. (881 N.m) on 8.1L models.
No TFP manual valve position switch change within 6 seconds.
The commanded gear is not 1st.
The TFP manual valve position switch indicates D4.
The transmission fluid temperature is greater than 68°F (20°C).