LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 678 (Door System, Mirror System & Window System) >> Repair Instructions >> Lock Actuator Replacement - Front Door >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the window glass.
  2. Remove the door trim panel. Refer to Trim Panel Replacement - Side Front Door .
  3. Remove the water deflector. Refer to Water Deflector Replacement - Front Door .
  4. Disconnect the inside door lock rod from the handle retainer clip.
    Fig 1: Inside Door Lock Rod
    G01714018Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the manual door lock rod from the door retainer clips.
    Fig 2: Disconnecting Manual Door Lock Rod From Door Retainer Clips
    G01714019Courtesy of GENERAL MOTORS CORP.
  6. Remove the rubber plug in order to disengage the outside handle rod retainer.
    Fig 3: Removing Rubber Plug
    G01714020Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the cylinder lock rod.
  8. Remove the bolts which retain the door lock actuator to the door.
  9. Remove the door lock actuator and control rods as an assembly.
  10. Disconnect the electrical connector from the door lock actuator, if equipped.
  11. Fig 4: Disconnecting Electrical Connector From Door Lock Actuator
    G01714021Courtesy of GENERAL MOTORS CORP.
  12. Remove the control rods as necessary.