Installation Procedure
WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Install the DIC and power outlet bracket to IP extension. Tighten the bracket screws to 1.6 N.m (14 lb in).
- Install the speaker. Refer to SPEAKER REPLACEMENT - FRONT FLOOR CONSOLE (TWEETER) .
- Install the extension to the IP.
- Install the 4 retaining screws. Tighten the screws to 1.6 N.m (14 lb in).
- Connect the wire connector and attach to the extension.
Important: Verify that the wire or connector is NOT outside the console.
- Carefully move the console forward to attach to the extension.
- Install the console to the extension by slightly lifting up over the extension hooks and then downwards.
- Install the 2 retaining screws. Tighten the screws to 1.6 N.m (14 lb in).
- Connect the wire connectors and attach to the console to prevent rattling during vehicle movement.
- Install the bolts retaining the console to the mounting bracket. Tighten the bolts to 3.5 N.m (31 lb in).
- Install the amplifier, if equipped. Refer to AMPLIFIER REPLACEMENT (BASE) .
- Install the console bin. Refer to Console Storage Bin Replacement (Non-Luxury) , Console Storage Bin Replacement (Luxury) , or Console Storage Bin Replacement (Pro) .
- Install the CD player. Refer to REMOTE CD PLAYER REPLACEMENT .
- Install the DIC. Refer to Driver Information Center Replacement .
- Install the console bezel. Refer to Instrument Panel (I/P) Extension Replacement (Luxury) .