LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 67 (Engine Mechanical - 6.6L (On-Vehicle)) >> Removal & Installation >> Engine Flywheel >> Inspection (M/T)

Inspection (M/T)

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect flywheel for missing or damaged clutch plate pins, excessive wear to the ring gear teeth, broken damper springs, loose rivets or clutch surface for cracking, hot spots, grooved, or excessive wear.
  2. Replace flywheel assembly if any of conditions are found. Replace ring gear on flywheel if teeth are worn or damaged.
  3. Heat ring gear evenly with a torch. Do not overheat. Using a hammer and punch, remove ring gear.
scientia non olet · About LEMON Manuals