Installation Procedure
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
Important: The body must be dry and the door must be closed prior to molding installation.
- If the molding is being reused, apply new adhesive tape (2) to the molding.
- Align the molding using the locator pins (1).
- Remove the backing from the tape (2).
- Align and press the molding (3) to the door. Assure proper wetout of the adhesive by applying heavy hand pressure against the molding, rubbing along the entire length of the molding. Wear clean gloves or use a clean towel while performing this step.