Turn Signal and Multifunction Switch Assembly - Assemble - Off Vehicle

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.

Important: The electrical contact on the turn signal and multifunction switch assembly must rest on the turn signal cancel cam assembly.

Install the turn signal and multifunction switch assembly.
CAUTION: Refer to FASTENER NOTICE .
Secure by using 2 pan head tapping screws.
Tighten

Tighten the screws to 7 N.m (62 lb in).

Fig 1: Installing Turn Signal & Multifunction Switch Assembly
Courtesy of GENERAL MOTORS CORP.
Reconnect the connectors of the turn signal and multifunction switch assembly.
CAUTION: Refer to SIR INFLATOR MODULE COIL CAUTION .
Install the wire harness straps.
Install the wire harness assembly into the wire restraint clip (1).

Fig 2: Installing Wire Harness Assembly

Courtesy of GENERAL MOTORS CORP.

Install the upper and lower trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle .
Enable the inflatable restraint steering wheel module. Refer to ACTIVATING SYSTEM .