LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 647 (Power Seat System) >> Repair Instructions >> Seat Cushion Trim Cover and Pad Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the seat cushion heater element, if equipped. Refer to Seat Cushion Heater Element Replacement - Front .
  2. Install the seat cushion pad to the seat cushion frame.
    3. Fig 1: Installing Seat Cushion Trim Cover To Pad
    GM386196Courtesy of GENERAL MOTORS CORP.
  3. Using a side motion, carefully pull the seat cushion cover onto the frame pad.
    4. Fig 2: Attaching Seat Trim Cover To Seat Cushion Frame
    GM386197Courtesy of GENERAL MOTORS CORP.
  4. Attach the seat trim cover to the seat cushion frame.
    5. Fig 3: View Of Lumbar Cable And Front Seat Cushion Frame Components
    GM407184Courtesy of GENERAL MOTORS CORP.
  5. Install the lumbar actuator (5).
  6. Install the seat switch bezel. Refer to Seat Switch Bezel Replacement .
    7. Fig 4: View Of Seat Cushion Front Nuts & Rear Plastic Holders
    GM378531Courtesy of GENERAL MOTORS CORP.
  7. Place the cushion on the rear plastic holders (1) on the underside of the seat cushion, and push rearward.
    8. Fig 5: View Of Lumbar Cable And Front Seat Cushion Frame Components
    GM407184Courtesy of GENERAL MOTORS CORP.
  8. Connect the lumbar cable to the underside of the seat cushion (6). Connect the lumbar wire harness (if equipped with power lumbar).
  9. Connect the electrical connectors.
    10. Fig 6: View Of Seat Cushion Front Nuts & Rear Plastic Holders
    GM378531Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  10. Install the front nuts (2) onto the studs on the underside of the cushion.

    Tighten:  Tighten the nuts to 21 N.m (15 lb ft).

  11. Feed the seat belt through the seat cushion.
    12. Fig 7: Installing Seat Belt Anchor Nut
    GM381493Courtesy of GENERAL MOTORS CORP.
  12. Install the outboard seat belt anchor nut.

    Tighten:  Tighten the nut to 53 N.m (39 lb ft).

  13. Install the seat trim panel. Refer to Trim Panel Replacement - Front Seat .
scientia non olet · About LEMON Manuals