LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 647 (Power Seat System) >> Repair Instructions >> Seat Back Cover and Pad Replacement - Rear (60/40 - 50/50 Split) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear seat from the vehicle. Refer to Seat Replacement - Rear (60/40 Split)  or Seat Replacement - Rear (50/50 Split 2nd Rear) .
  2. Remove the seat back folding cover, if necessary. Refer to Seat Back Cover Replacement - Rear Folding .
  3. Remove the armrest from the seat back, if equipped. Refer to Armrest Replacement - Rear Seat (60/40 - 50/50 Split)  or Armrest Replacement - Rear Seat (Bucket) .
    4. Fig 1: Rear Seat Back Cover & Pad (60/40 - 50/50 Split)
    GM276555Courtesy of GENERAL MOTORS CORP.
  4. Remove the head restraints (1) from the seat back. Refer to Head Restraint Replacement (Non-Cadillac)  or Head Restraint Replacement (Cadillac)  or Head Restraint Replacement (Folding) .
  5. Remove the seat back plastic cover (10) from the seat back frame, if equipped.
  6. Release the J-clips from the seat back cover.
  7. Release the hook, and the loop strips retaining the seat back cover (2) to the foam pad (12).
  8. In order to ease removal, place a piece of cardboard between the seat back cover and the foam pad.
  9. Working from side to side, carefully lift the seat back cover from the foam pad.
scientia non olet · About LEMON Manuals