LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 644 (Steering Wheel & Steering Column) >> Repair Instructions >> Tilt Spring Replacement - Steering Column >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to Tilt Spring Caution in Cautions and Notices.
  1. Use the tilt lever to tilt the column to the UP position.
  2. Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement - On Vehicle .
    3. Fig 1: Removing Tilt Spring From Steering Column Support Assembly
    GM293248Courtesy of GENERAL MOTORS CORP.
  3. Remove the tilt spring (1) in the following manner:
    1. Pry the tilt spring up until a bulge occurs and most of the tilt spring tension is removed.
    2. Secure the tilt spring with locking pliers and continue prying until the tilt spring disengages from the post of the steering column support assembly (3).
    4. Fig 2: Identifying Spring Guide Components
    GM293249Courtesy of GENERAL MOTORS CORP.
  4. Remove the spring guide (1) from the tilt spring (2).
scientia non olet · About LEMON Manuals