Steering Shaft, Lower Bearing, and Jacket - Assemble - Off Vehicle (Floor Shift Standard)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Attach the steering column support assembly (2) to the steering column jacket assembly (3) with 4 new TORX® head screws (1).
Tighten: Tighten the screws to 17 N.m (13 lb ft).
- Install the steering shaft assembly (1) into the steering column support assembly (2) and the steering column jacket assembly (3).
- Install the adapter and bearing assembly (1) onto the steering column jacket assembly.
- Align the tab on the adapter and bearing assembly (1) with the slot in the steering column jacket assembly.
- Push the adapter and bearing assembly (1) onto the steering shaft assembly until the tab snaps into the slot.
- Install the turn signal and multifunction switch assembly. Refer to Turn Signal and Multifunction Switch Assembly - Assemble - Off Vehicle .
- Install the electronic lock module assembly. Refer to Electronic Column Lock Module - Assemble - Off Vehicle .
- Install the steering column into the vehicle. Refer to Steering Column Replacement .
- Install the steering wheel onto the steering column. Refer to Steering Wheel Replacement .
- Enable the inflatable restraint steering wheel module. Refer to ACTIVATING SYSTEM in SIR.
Fig 1: View Of TORX(R) Head Screws, Steering Column Support Assembly & Steering Column Jacket Assembly
NOTE:
Refer to FASTENER NOTICE
in Cautions and Notices.
Fig 2: View Of Steering Shaft Assembly, Steering Column Support Assembly & Steering Column Jacket Assembly