LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 644 (Steering Wheel & Steering Column) >> Repair Instructions >> Ignition Lock Cylinder Replacement - On Vehicle >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Using Screwdriver To Rotate Lock Cylinder Housing Gear
    GM1413835Courtesy of GENERAL MOTORS CORP.
  1. Install the key into the lock cylinder.
    2. IMPORTANT: The gears between the ignition switch and the lock cylinder housing must be in the correct position. Failure to do so will cause a misalignment of the gears in the ignition switch and the lock cylinder housing, which may result in a NO START or BATTERY DRAIN.
  2. Use a screwdriver to rotate the lock cylinder housing gear clockwise to the start position - allowing it to spring return into the RUN position.
    3. Fig 2: View Of Lock Cylinder At Lock Cylinder Housing
    GM1413837Courtesy of GENERAL MOTORS CORP.
  3. Align the lock cylinder and install into the lock cylinder housing.
  4. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement - On Vehicle .
  5. Install the hush and knee bolster. Refer to KNEE BOLSTER REPLACEMENT (NON-LUXURY) or KNEE BOLSTER REPLACEMENT (LUXURY) in Instrument Panel, Gages, and Console.
  6. Enable the SIR system. Refer to ACTIVATING SYSTEM in SIR.
  7. Connect the negative battery cable. Refer to BATTERY NEGATIVE CABLE DISCONNECT/CONNECT PROCEDURE (SINGLE BATTERY) or BATTERY NEGATIVE CABLE DISCONNECT/CONNECT PROCEDURE (AUXILIARY BATTERY) in Engine Electrical.
scientia non olet · About LEMON Manuals