LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 644 (Steering Wheel & Steering Column) >> Repair Instructions >> Horn Switch Replacement - On Vehicle >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Horn Contact Plate, Steering Wheel & Screws
    GM776565Courtesy of GENERAL MOTORS CORP.
  1. Install the horn switch (2) to the steering wheel (3).
    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Connect the horn contact plate (2) captured screws (1,4) to the steering wheel (3).

    Tighten:  Tighten the horn contact plate captured screws to 5.5 N.m (50 lb in).

    3. Fig 2: View Of Horn Plunger At Steering Column
    GM399638Courtesy of GENERAL MOTORS CORP.
  3. Install the horn plunger to the steering column.
  4. Install the inflator module. Refer to REMOVAL & INSTALLATION (DRIVER-SIDE) in SIR.
  5. Enable the SIR system. Refer to ACTIVATING SYSTEM in SIR.
scientia non olet · About LEMON Manuals