Installation Procedure
WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Install the cable taking care to correctly route the cable through the guides and the body mounts.
- Install the cable to the backing plate by pressing the cable into place until locking tabs snap into place, 15-Series utilities.
- Attach the cable to the lever.
- Install the cable taking care to correctly route the cable through the guides and the body mounts.
- Install the cable to the backing plate by pressing the cable into place until locking tabs snap into place, all except 15-Series utilities.
- Attach the cable to the lever.
- Install the cable to the track bar and secure with the clips. Verify that the clips are installed between the locators on the track bar, 15-Series utilities.
- Install the cable to the right and left side guides.
- Install the cable to the mounting bracket until the locking tabs snap into place.
- Bolt the cable to the differential clips. Tighten the bolt to 25 N.m (18 lb ft).
Important: After installing the cable to the rear axle holding clip, verify that clip is securely retaining the cable. If not, crimp the clip by hand taking care not to pinch or kink the cable.
- Install the cable to the differential clip.
- Connect the cable to the equalizer.
- Tighten the nut to the intermediate cable at the equalizer. Tighten the nut to 3.5 N.m (31 lb in).
- Remove the safety stands.
- Lower the vehicle.
- Adjust the park brake cable. Refer to Park Brake Adjustment .