LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 641 (Parking Brake System) >> Repair Instructions >> Park Brake Cable Replacement - Left Rear (Without RPO NYS) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the cable taking care to correctly route the cable through the guides and the body mounts.
  2. Install the cable to the backing plate by pressing the cable into place until locking tabs snap into place, 15 series utilities.
  3. Install the cable to the lever.
  4. Install the cable taking care to correctly route the cable through the guides and the body mounts.
  5. Install the cable to the backing plate by pressing the cable into place until locking tabs snap into place, all except 15 series utilities.
  6. Install the cable to the lever.
  7. Install the cable at the shock absorber bracket and install the bolt. Tighten the bolt to 25 N.m (18 lb ft).
  8. Install the cable to the mounting bracket until the locking tabs snap into place.
  9. Connect cable end to the equalizer.
  10. Tighten the nut to the intermediate cable at the equalizer. Tighten the nut to 3.5 N.m (31 lb in).
  11. Remove the safety stands.
  12. Lower the vehicle.
  13. Adjust the park brake cable. Refer to Park Brake Adjustment .
scientia non olet · About LEMON Manuals