LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 631 (Body Rear End) >> Repair Instructions >> Hinge Replacement - Rear Cargo Door - Lower Body Side >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Repair any damage done to the pillar during the drilling or the removal.
  2. Position the service hinge within the scribe marks on the pillar.
    3. Fig 1: Center Punching Bolt Location On Pillar
    GM637666Courtesy of GENERAL MOTORS CORP.
  3. Center punch each bolt location on the pillar according to the service hinge.
    4. Fig 2: Drilling Pilot Hole At Punch Locations
    GM637668Courtesy of GENERAL MOTORS CORP.
  4. Drill a 3 mm (1/8 in) pilot hole at each punch location.
    5. Fig 3: Drilling Hole At Pilot Locations
    GM637671Courtesy of GENERAL MOTORS CORP.
  5. Drill a 13 mm (1/2 in) hole at the pilot locations.
  6. Clean and prepare all bare metal surfaces.
    7. IMPORTANT: Prior to refinishing, refer to GM 4901MD-99 Refinish Manual for recommended products. Do not combine paint systems. Refer to paint manufacturer's recommendations.
  7. Apply an approved anti-corrosion primer.
    8. Fig 4: Applying Caulk To Entire Hinge Mounting Surface
    GM637673Courtesy of GENERAL MOTORS CORP.
  8. Apply full-body caulk to the entire hinge mounting surface.
    9. Fig 5: Aligning & Installing Rear Cargo Door Hinge (Lower Body Side)
    GM637674Courtesy of GENERAL MOTORS CORP.
  9. Align the hinge with the holes in the pillar.
    10. Fig 6: Installing Rear Cargo Door Hinge Fasteners (Lower Body Side)
    GM637676Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  10. Install the hinge fasteners.

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

    11. Fig 7: Positioning & Welding Rear Body Opening Lower Filler
    GM637678Courtesy of GENERAL MOTORS CORP.
  11. Position the rear body opening lower filler and mig weld in place at factory weld locations.
  12. Clean and prepare all weld surfaces.
  13. Refinish the metal surfaces as necessary.
  14. Align and install all of the related panels and the components.
scientia non olet · About LEMON Manuals