LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 630 (Wiring Systems (General Information)) >> Repair Instructions >> Instrument Panel Electrical Center or Junction Block Replacement - Right >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the wiring connectors to the rear of the IP wiring harness junction block.
  2. Feed the IP wiring harness junction block through the hole in the IP.
  3. Connect the lower IP light bulb by twisting the bulb socket clockwise while pushing in.
    4. Fig 1: IP Wiring Harness Junction Block
    G01696402Courtesy of GENERAL MOTORS CORP.
  4. Connect the IP wiring harness junction block to the IP by pressing on both clips and pushing until sealed.
    5. Fig 2: IP Wiring Connector
    G01696403Courtesy of GENERAL MOTORS CORP.
  5. Connect the wiring connector(s) onto the front of the IP wiring harness junction block and connect the harness to the fastener.
  6. Install the right side end panel.
  7. Connect the negative battery cable(s).
scientia non olet · About LEMON Manuals