LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 630 (Wiring Systems (General Information)) >> Repair Instructions >> Body Wiring Harness Junction Block Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to BATTERY DISCONNECT CAUTION .
  1. Disconnect the negative battery cable(s).
  2. Remove the harness from the front of the body wiring harness junction block.
    3. Fig 1: Body Wiring Harness Junction Block Cover
    G01696404Courtesy of GENERAL MOTORS CORP.
  3. Unsnap the cover from the body wiring harness junction block.
  4. Unsnap the top pivots and rotate the body wiring harness junction block (1) down. Unsnap the lower pivots and remove the body wiring harness junction block from the bracket (2).
  5. Disconnect the two 68-way IP connectors.
  6. Disconnect the remaining wiring connectors from the body wiring harness junction block.
  7. Remove the body wiring harness junction block from the vehicle.
    Fig 2: Body Wiring Harness Junction Block
    G01696405Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals