LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 630 (Wiring Systems (General Information)) >> Diagnostic Information and Procedures >> Pull to Seat Connectors >> Terminal Removal

Terminal Removal

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Follow the steps below in order to repair pull-to-seat connectors.

Fig 1: Pull to Seat Connectors
G01696382Courtesy of GENERAL MOTORS CORP.
  1. Remove the terminal position assurance (TPA) device, the connector position assurance (CPA) device, and/or the secondary lock.
  2. Separate the connector halves.
  3. Using the proper pick or removal tool insert into the front of the connector body.
  4. Grasp the wire at the back of the connector body and gently pull the terminal (1) from the connector body (3).
  5. Inspect the terminal for damage, if damaged refer to Terminal Repair.
  6. Reform the locking tang (2) if the terminal is being reused.
scientia non olet · About LEMON Manuals