LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 629 (Electronic Suspension System - Real Time Damping (RTD)) >> Repair Instructions >> Rear Position Sensor Replacement - Electronic Suspension - Right (25 Series) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 GMC Yukon. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
  2. Remove the wheel from the vehicle. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in Tires and Wheels.
    Fig 1: Disconnecting Sensor Harness Connector
    G01662918Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the sensor harness connector from the vehicle harness connector.
  4. Disconnect the sensor link from the ball stud.
  5. Remove the bolts.
  6. Remove the position sensor from the vehicle.
    Fig 2: Removing Rear Position Sensor Replacement - Right (25 Series)
    G01662919Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals