LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 627 (Seat Belt System) >> Repair Instructions >> Seat Belt Retractor Replacement - No. 2 Rear (Bench) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the retractor.
    NOTE: Refer to FASTENER NOTICE .
  2. Install the seat belt retractor bolt (1) to the seat frame.

    Tighten:  Tighten the bolt to 53 N.m (39 lb ft).

    Fig 1: Rear Seat Belt Retractor Bolt (Bench)
    GM841688Courtesy of GENERAL MOTORS CORP.
  3. Install the seat back cover and pad. Refer to SEAT BACK COVER AND PAD REPLACEMENT - REAR (60/40 - 50/50 SPLIT) or SEAT BACK COVER AND PAD REPLACEMENT - REAR (BENCH) .
scientia non olet · About LEMON Manuals