LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 624 (Transfer Case - NVG 261-NP2 (2-Speed Manual)) >> Repair Instructions >> Transfer Case Input Shaft Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Important:  When installing the input shaft seal, make sure that the part numbers on the seal are facing outward (toward the technician).

  1. Align the transfer case input shaft seal evenly on the input shaft.

    Important:  The input shaft seal should be even with the surface of the transfer case after installation.

  2. Using the J 42738,  install the transfer case input shaft seal.
  3. Install the transfer case assembly. Refer to Transfer Case Assembly Replacement .
  4. Check the transfer case fluid level. Refer to Transfer Case Fluid Replacement .
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals