Conditions For Running DTC P0502

WARNING: This page is about a different car, the 2002 GMC Yukon XL, 2002 GMC Sierra, 2002 Chevrolet Suburban, and 2002 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

DTC will run under the following conditions:

No MAF sensor DTCs P0101, P0102 or P0103.
No MAP sensor DTCs P0106, P0107 or P0108.
No TP sensor DTCs P0122 or P0123.
No TFP manual valve position switch DTC P1810.
No ISS DTCs P0716 or P0717.
The engine torque must be between 80 ft. lbs. (108 N.m) and 425 ft. lbs. (576 N.m) on 6.0L models, or 650 ft. lbs. (881 N.m) on 8.1L models.
No change in 4WD Low for at least 2 seconds.
The input shaft speed is greater than 1400 RPM.
The gear range is not Park or Neutral.
The system voltage is 8-18 volts.
Throttle angle is greater than 10 percent.
The engine is running greater than 400 RPM for greater than 7 seconds.