LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 618 (Wiring Systems (General Information)) >> Diagnostic Information And Procedures >> Push To Seat Connectors >> Terminal Removal

Terminal Removal

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.

Follow the steps below in order to repair push to seat connectors.

  1. Remove the terminal position assurance (TPA) device, the connector position assurance (CPA) device, and/or the secondary lock.
  2. Separate the connector halves (1).
    3. Fig 1: Identifying Push To Seat Connector Halves
    G01754660Courtesy of GENERAL MOTORS CORP.
  3. Use the proper pick or removal tool (1) in order to release the terminal.
    4. Fig 2: Identifying Push to Seat Connector Terminal Removal Tool
    G01754661Courtesy of GENERAL MOTORS CORP.
  4. Gently pull the cable and the terminal (2) out of the back of the connector.
  5. Re-form the locking device if you are going to reuse the terminal (1).
    6. Fig 3: Identifying Locking Device Reforming Tool
    G01754662Courtesy of GENERAL MOTORS CORP.
  6. To repair the terminal, refer to Terminal Repair  .
scientia non olet · About LEMON Manuals