LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 612 (Door System, Mirror System & Window System) >> Repair Instructions >> Door Adjustment - Sliding >> Up and Down Adjustment

Up and Down Adjustment

WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the sliding side door upper roller cover. Refer to Roller Bracket Cover Replace - Sliding Door Upper .
  2. Remove the sliding side door lower roller cover.
  3. Loosen the bolts that retain the upper front roller to the door.
    Fig 1: Removing Sliding Side Door Lower Roller Cover
    G01736991Courtesy of GENERAL MOTORS CORP.
  4. Loosen the bolts that retain the lower front roller to the door.
  5. Loosen the nuts that retain the rear roller to the door.
  6. Adjust the door up or down until you obtain the desired position.
    CAUTION: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  7. Tighten the nuts that retain the rear roller to the door. Tighten the nuts to 25 N.m (18 lb ft).
    Fig 2: Loosening Bolts & Nuts Retaining Rollers To Door
    G01736992Courtesy of GENERAL MOTORS CORP.
  8. Tighten the bolts that retain the upper front roller to the door. Tighten the bolts to 25 N.m (18 lb ft).
    Fig 3: Tightening Bolts Retaining Upper Front Roller To Door
    G01736993Courtesy of GENERAL MOTORS CORP.
  9. Tighten the bolts that retain the lower front roller to the door. Tighten the bolts to 25 N.m (18 lb ft).
  10. Install the sliding side door lower roller cover.
  11. Install the sliding side door upper roller cover. Refer to Roller Bracket Cover Replace - Sliding Door Upper .
Fig 4: Installing Sliding Side Door Lower Roller Cover
G01736994Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals