LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 611 (Power Seat System) >> Repair Instructions >> Drive Cable Replacement - Power Seat >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora and 2001 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to SIR HANDLING CAUTION in Cautions and Notices.
  1. Disable the SIR system. Refer to DISABLING SYSTEM in SIR.
  2. Remove the seat cushion. Refer to Seat Cushion Replacement - Front  .
  3. If the cable is equipped with a position sensor, remove the sensor retention clip and disconnect the electrical connector.
  4. Squeeze the collars of the cable in order to release the cable.
    Fig 1: Removing Sensor Electrical Connector
    G01803920Courtesy of GENERAL MOTORS CORP.
  5. Pull the cable out of the fittings until the cable ends clear the fittings.
  6. Remove the cable or cable/sensor assembly.
    Fig 2: Removing Cable/Sensor Assembly
    G01803921Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals