LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 608 (Instrument Panel, Gauges & Console) >> Repair Instructions >> Trim Panel Replacement - Instrument Panel (IP) Upper >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. If equipped with Air Conditioning (A/C), set the air flow control to the Instrument Panel (IP) vent position.
  2. Apply the parking brake to prevent the vehicle from moving.
  3. If the transmission is automatic, move the shift lever all the way down.
  4. Tilt the steering wheel to the full down position.
  5. Remove the IP cluster trim plate bezel. Refer to Bezel Replacement - IP Cluster .
  6. Remove the end panels. The left panel is shown, and the right panel is similar.
  7. Remove the right side air outlets.
    8. Fig 1: Removal of Trim Plate Bezel
    G01697233Courtesy of GENERAL MOTORS CORP.
  8. Remove the assist handle by depressing the release tabs accessed through the air outlet duct holes.
  9. Remove the windshield pillar garnish moldings. Refer to GARNISH MOLDING REPLACEMENT - WINDSHIELD PILLAR .
  10. Remove the bolts retaining the panel to IP assembly.
    11. Fig 2: Removal of Garnish Molding
    G01697234Courtesy of GENERAL MOTORS CORP.
  11. Lift the trim panel up to disconnect the electrical connector (1) to the ambient light sensor on the underside of the trim panel.
    12. Fig 3: Locating Electrical Connector
    G01697235Courtesy of GENERAL MOTORS CORP.
  12. Remove the trim panel from the IP assembly.
    13. Fig 4: Removing Trim Panel from IP Assembly
    G01697236Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals