LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 605 (Wiring Systems (General Information)) >> Diagnostic Information And Procedures >> Push to Seat Connectors >> Terminal Removal

Terminal Removal

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.

Follow the steps below in order to repair push to seat connectors.

  1. Remove the terminal position assurance (TPA) device, the connector position assurance (CPA) device, and/or the secondary lock.
  2. Separate the connector halves (1).
    Fig 1: Separating Connector Halves
    G01802741Courtesy of GENERAL MOTORS CORP.
  3. Use the proper pick or  removal tool (1) in order to release the terminal.
  4. Gently pull the cable and the terminal (2) out of the back of the connector.
    5. Fig 2: Releasing Terminal
    G01802742Courtesy of GENERAL MOTORS CORP.
  5. Re-form the locking device if you are going to reuse the terminal (1).
    6. Fig 3: Re-Forming Locking Device
    G01802743Courtesy of GENERAL MOTORS CORP.
  6. To repair the terminal, refer to Terminal Repair.
scientia non olet · About LEMON Manuals