LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 597 (Engine Mechanical - 4.0L (Unit Repair)) >> Repair Instructions >> Crankshaft Balancer Removal >> Tools Required

Tools Required

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora and 2001 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the J 44214  to the engine block.
  2. Secure the flywheel in order to prevent crankshaft rotation.
    Fig 1: Identifying J 44214
    G01815703Courtesy of GENERAL MOTORS CORP.
  3. Remove the crankshaft balancer bolt.
    Fig 2: Removing Crankshaft Balancer Bolt
    G01815704Courtesy of GENERAL MOTORS CORP.
  4. Place the remover pilot in the end of the crankshaft.
  5. Position the legs of the J 41816  onto the backside of the balancer inner hub.
  6. Tighten the center screw on the puller until the balancer pulls clear of the crankshaft end.
    Fig 3: Pulling Crankshaft Balancer
    G01815705Courtesy of GENERAL MOTORS CORP.
  7. Remove the crankshaft balancer.
    Fig 4: Removing Crankshaft Balancer
    G01815706Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals