LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 597 (Engine Mechanical - 4.0L (Unit Repair)) >> Repair Instructions >> Camshaft Cover Installation - Right >> Tools Required

Tools Required

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora and 2001 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.

J 44212  Camshaft Holding Tool

  1. Remove the J 44212  from the right cylinder head camshafts.
    Fig 1: Removing J 44212
    G01817340Courtesy of GENERAL MOTORS CORP.
  2. Ensure new camshaft cover seals are installed.
  3. Place the right camshaft cover in position on the cylinder head by aligning the bolt holes.
    CAUTION: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the camshaft cover bolts.

    Tighten 

    Tighten the camshaft cover bolts to 10 N.m (89 in lbs).

    Fig 2: Installing Right Camshaft Cover
    G01817341Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals