LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 596 (Engine Mechanical - 3.5L (Unit Repair)) >> Repair Instructions >> Ignition Module Installation - Right (with RPO NC1)

Ignition Module Installation - Right (with RPO NC1)

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora and 2001 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Press the spark plug boots onto the ignition coil assembly.
    Fig 1: Installing Spark Plug Boots
    G01815517Courtesy of GENERAL MOTORS CORP.
  2. Lower the ignition coil assembly into the camshaft cover valley. DO NOT damage the ignition coil assembly's perimeter seal.
    CAUTION: Refer to in FASTENER NOTICE .
  3. Install the ignition coil assembly bolts.

    Tighten 

    Tighten the ignition coil assembly bolts to 9 N.m (80 in lbs).

    Fig 2: Installing Ignition Coil Assembly
    G01815518Courtesy of GENERAL MOTORS CORP.
  4. Install the A.I.R. vacuum control solenoid/fuel injector sight shield bracket.
  5. Install the A.I.R. vacuum control solenoid/fuel injector sight shield bracket bolts.

    Tighten 

    Tighten the A.I.R. vacuum control solenoid/fuel injector sight shield bracket bolts to 8 N.m (71 in lbs).

    Fig 3: Installing A.I.R. Vacuum Control Solenoid/Fuel Injector Sight Shield Bracket
    G01815519Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals