LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 596 (Engine Mechanical - 3.5L (Unit Repair)) >> Repair Instructions >> Balance Shaft Cover Installation

Balance Shaft Cover Installation

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora and 2001 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the balance shaft cover gasket in position on the cylinder block. Ensure that any remaining gasket material is removed from the cylinder block and cover.
  2. Lower the balance shaft cover into the engine valley.
    CAUTION: Refer to in FASTENER NOTICE .
  3. Install the balance shaft cover bolts.

    Tighten 

    Tighten the balance shaft cover bolts to 12 N.m (106 in lbs).

    Fig 1: Installing Lower Balance Shaft Cover & Gasket
    G01815432Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals