LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 595 (Rear Wheel Steering System) >> Repair Instructions >> Wheel Hub & Bearing Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the wheel hub and bearing (3) to the vehicle.
  2. Install the wheel hub and bearing retaining bolts. Tighten the bolts to 180 N.m (132 ft lbs).
  3. Install the wheel drive shaft retaining nut. Tighten the nut to 250 N.m (184 ft lbs).
  4. Install the retainer (3) and cotter pin (2) to the wheel drive shaft nut.
  5. Install the dust cap (4).
  6. Install the brake rotor. Refer to BRAKE ROTOR .
  7. Install the tire and wheel.
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals