LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 595 (Rear Wheel Steering System) >> Repair Instructions >> Rear Wheel Steering Tie Rod End Replacement - Inner >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the inner tie rod to the steering gear.
  2. Using the J 44665-2  (2) tighten the inner tie rod (1). Tighten the inner tie rod to 100 N.m (74 ft lbs).
  3. Install the inner tie rod support clamp to the steering gear. Use the J 44665-1  (1) and the J 44665-2  (2) in order to tighten the inner tie rod support clamp. Tighten the inner tie rod support clamp to 25 N.m (18 ft lbs).
  4. Install the rack and pinion boot to the steering gear. Refer to Rack & Pinion Boot Replacement .
  5. Install the tire and wheel.
  6. Lower the vehicle.
  7. Perform a four wheel alignment. Refer to SPECIFICATIONS .
scientia non olet · About LEMON Manuals