Turn Signal Switch Housing - Assemble - Off Vehicle (Standard)
WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Important: The switch mounting bracket must be pressed firmly against the steering column tilt head.
- Slide the turn signal switch housing onto the steering column shaft assembly.
- Install the turn signal and multifunction switch assembly only. Refer to Turn Signal & Multifunction Switch Assembly - Assemble - Off Vehicle .
- Install the turn signal cancel cam and upper bearing thrust. Refer to Turn Signal Cancel Cam & Bearing Thrust Washer - Assemble - Off Vehicle .
- Enable the inflatable restraint steering wheel module. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .