LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 594 (Steering Wheel And Steering Column) >> Repair Instructions >> Steering Column Trim Covers Replacement - On Vehicle >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Important:  If the snap on/off feature on the trim covers was damaged during the removal procedure, you must use screws for the installation procedure.

  1. Install the upper steering column trim cover (2).
  2. If necessary, install the screw that retains the upper steering column trim cover to the steering column. Tighten the upper steering column trim cover retaining screws to 1.5 N.m (13 lb in).
  3. Install the lower steering column trim cover.
  4. Match the tabs slots onto the lower cover with the locking tabs on the upper cover.
  5. Tilt the lower shroud up.
  6. If no screws were present, gently snap the lower trim cover to the upper trim cover.
  7. If necessary, install the screws (1) that retain the lower steering column trim cover to the steering column. Tighten the lower steering column trim cover retaining screws to 3.5 N.m (31 lb in).
  8. Install the tilt lever to the steering column. Refer to Tilt Lever Replacement - On Vehicle .
  9. Install the steering wheel. Refer to Steering Wheel Replacement .
  10. Enable the SIR system. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .
scientia non olet · About LEMON Manuals