LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 594 (Steering Wheel And Steering Column) >> Repair Instructions >> Multifunction, Turn Signal & Hazard Switch Replacement - On Vehicle >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable the SIR system. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .
  2. Remove the knee bolster.
  3. Loosen the steering column bracket nuts.
  4. Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement - On Vehicle .
  5. Disconnect the steering column bulkhead connector from the vehicle harness.
    Fig 1: Steering Column Bulkhead Connector
    G01667160Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the gray and the black connectors (2) of the switch from the column bulkhead connector.
  7. Disconnect the automatic transmission shift lock control electrical connector.
    Fig 2: Automatic Transmission Shift Lock Control Electrical Connector
    G01667161Courtesy of GENERAL MOTORS CORP.
  8. Remove the wire harness straps from the steering column wire harness (1).
  9. Disconnect the park position switch electrical connection.
  10. Remove the multifunction switch retaining screws from the switch.
  11. Remove the multifunction turn signal/hazard switch.
    Fig 3: Multifunction Turn Signal/Hazard Switch
    G01667162Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals