LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 594 (Steering Wheel And Steering Column) >> Repair Instructions >> Ignition Lock Cylinder Replacement - On Vehicle >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the ignition lock cylinder into the steering column using the following procedure:
    1. 1.1. Align the positioning locking tab slot on the lock module assembly to the positioning tab on the ignition lock cylinder.
    2. 1.2. Push the lock cylinder in until the locking tab locks in the lock module assembly.
  2. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement - On Vehicle .
  3. Enable the SIR system. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .
  4. Perform the Passlock learn procedure. Refer to Programming Theft Deterrent System Components in Theft Deterrent.
scientia non olet · About LEMON Manuals