LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 592 (Power Steering System) >> Repair Instructions >> Tie Rod End Replacement - Outer >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the outer tie rod assembly (3) to the inner tie rod (1). Do not tighten the jam nut (2).
  2. Install the tie rod seal (2) to the outer tie rod assembly (1).
  3. Connect the outer tie rod assembly (1) to the steering knuckle (2).
  4. Install the torque prevailing nut (3) to the outer tie rod stud (1). Tighten the torque prevailing nut (3) to 50 N.m (37 ft lbs).

    Important:  Be sure the rack and pinion boot is not twisted after the toe adjustment.

  5. Check the wheel alignment. Refer to SPECIFICATIONS .
  6. Tighten the jam nut against the outer tie rod end. Tighten the nut to 68 N.m (50 ft lbs).
scientia non olet · About LEMON Manuals