LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 592 (Power Steering System) >> Repair Instructions >> Steering Gear Pitman Shaft & Housing Cover Replacement - Off Vehicle (700 Gear) >> Disassembly Procedure

Disassembly Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the nut (3).
  2. Remove the lock washer (2).
  3. Clean the exposed end of the pitman shaft.
    4. Fig 1: Removing Steering Gear Pitman Shaft
    G01667006Courtesy of GENERAL MOTORS CORP.
  4. Clean the steering gear housing (1).
  5. Use a wire brush to clean the pitman shaft splines.
  6. Loosen the adjuster lock nut (1)
  7. Remove the bolts (2).
  8. Remove the nut.
  9. Rotate the stub shaft (6) using a 12-point socket to center the steering gear (7).

    Important:  When removing the pitman shaft assembly, the pitman arm and its components may fall from the steering gear housing. Support the pitman arm and it components while removing the pitman shaft assembly.

  10. Remove the following items as an assembly:
    • The side cover (8)
    • The gasket (3)
    • The pitman shaft (4)
  11. Remove the (4) from the side cover (8).
    Fig 2: Pitman Shaft
    G01667007Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals