LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 592 (Power Steering System) >> Repair Instructions >> Power Steering Pump Replacement (8.1L) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place a drain pan under the vehicle.
  2. Remove the power steering pulley. Refer to Power Steering Pulley Replacement .
  3. Remove the nut (1) and clamp (3) retaining the filler neck (1) to the power steering pump, if equipped.
    Fig 1: Power Steering Pump Filler Neck
    G01666887Courtesy of GENERAL MOTORS CORP.
  4. Remove the bolts (2) from the front of the pump.
  5. Remove the bolts retaining the power steering mounting bracket.
    Fig 2: Power Steering Pump Assembly
    G01666888Courtesy of GENERAL MOTORS CORP.
  6. Remove the bolts from the rear of the pump.
  7. Remove the hoses from the pump.
  8. For vehicles with variable effort steering, disconnect the electrical connector.
  9. Remove the pump from the vehicle.
  10. Remove the rear bracket from the power steering pump.
    Fig 3: Power Steering Pump Rear Bracket
    G01666889Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals