Steering Column Tilt Head Housing - Off Vehicle
WARNING: This page is about a different car, the 2002 Chevrolet Monte Carlo and 2002 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
Tools Required
- J 23653-SIR Steering Column Lock Plate Compressor
- J 42137 Steering Column Lock Plate Compressor Adapter
- Install the signal switch housing assembly (2) secure by using the 3 flat head screws (1). Tighten the screws to 10 N.m (7 ft lbs).
- Install the inner race (4).
- Install the upper bearing inner race seat (3).
- Install the upper bearing spring (2).
- Lubricate the turn signal cancel cam assembly (1) with synthetic grease.
- Install the turn signal cancel cam assembly (1).
- Center the race and upper shaft assembly (1) to the 12 o'clock position (2).
- Install the shaft lock shield assembly (2).
Important: The bearing retainer must be firmly seated in the groove on the race and upper shaft assembly (3).
- Install the bearing retainer (1) using J 42137 and J 42137 .
- Install the inflatable restraint steering wheel module coil. Refer to Inflatable Restraint Steering Wheel Module Coil - Assemble - Off Vehicle .
- Enable the inflatable restraint steering wheel module. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .