LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 573 (Seat Belt System) >> Repair Instructions >> Seat Belt Buckle Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the seat belt buckle to the seat.
  2. Connect the electrical connector to the seat belt buckle, if equipped.
  3. Lift the buckle cover.
    CAUTION: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  4. Install the seat belt buckle retaining bolt to the seat.

    Tighten 

    Tighten the seat belt buckle retaining bolt to 52 N.m (38 ft lbs).

Fig 1: Installing Seat Belt Buckle - Front
G01737580Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals