LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 57 (Disc Brakes & Drum Brakes) >> Trouble Shooting >> Disc Brake System >> Disc Brake Rotor Surface And Wear Inspection

Disc Brake Rotor Surface And Wear Inspection

WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the tire and wheel assemblies removed and the brake rotors retained by wheel lug nuts, clean the braking (friction) surfaces of the brake rotor with denatured alcohol or an equivalent approved brake cleaner.
  2. Inspect the braking surfaces of the brake rotor for the following braking surface conditions:
    • Heavy rust and/or pitting Light surface rust can be removed with an abrasive disc; heavy surface rust and/or pitting must be removed by refinishing the rotor.
    • Cracks and/or heat spots.
    • Excessive blueing discoloration.
  3. If the braking surfaces of the brake rotor exhibits one or more of the Braking Surface Conditions, the rotor requires refinishing or replacement.
  4. Using a micrometer calibrated in ten-thousands of an inch, measure and record the thickness variation of the brake rotor at 4 or more points, around the rotor. Ensure that the measurements are only taken within the brake pad lining contact area and that the micrometer is positioned the same distance from the outside edge of the rotor for each measurement.
  5. Compare the thickness variation recorded to specification. See DISC BRAKE SPECIFICATIONS  .
  6. If the brake rotor thickness variation exceeds the specification, the rotor requires refinishing or replacement.
  7. Using the micrometer, measure and record any grooves present on the rotor braking surface.
  8. Compare the groove (scoring) depth recorded to specification. See DISC BRAKE SPECIFICATIONS  .
  9. If the brake rotor scoring depth exceeds the specification, or if an excessive amount of scoring is present, the rotor requires refinishing or replacement.
  10. Mount a dial indicator, (J-8001) or equivalent, and position the indicator button so it contacts the brake rotor at a 90 degree angle, approximately 0.5 in (13 mm) from the rotor's outer edge.
  11. Measure and record the lateral runout of the brake rotor.
    1. Rotate the rotor until the lowest reading is displayed on the indicator dial, then zero the dial.
    2. Rotate the rotor until the highest reading is displayed on the dial.
    3. Measure and record the amount of sealed wheel bearing play, then subtract the bearing play from the lateral runout recorded to obtain the true amount of lateral runout.
  12. Compare the lateral runout of the brake rotor to specification. See DISC BRAKE SPECIFICATIONS  .
  13. If the brake rotor lateral runout exceeds the specification, the rotor requires refinishing or replacement.
scientia non olet · About LEMON Manuals