LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 57 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Disc Brake Hardware >> Removal

Disc Brake Hardware: Removal

WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the disc brake caliper bolts.
  2. Using a C-clamp installed to the center of the outer disc brake pad and the back of the caliper, slowly compress the caliper piston into its bore just enough to remove the caliper from the mounting bracket.
  3. Remove the disc brake caliper from the mounting bracket.
  4. Remove the disc brake pads from the disc brake caliper bracket.
  5. Remove the disc brake pad retainers from the disc brake caliper bracket.
  6. Remove the caliper pins from the disc brake caliper mounting bracket.
  7. Remove the caliper pin boots from the disc brake caliper mounting bracket. See Figure .
  8. Lightly wire brush all brake pad contact areas in order to remove any corrosion.
scientia non olet · About LEMON Manuals