LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 567 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rear Quarter (Luxury Y91) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the push-in-retainers from the rear quarter panel molding.
  2. Remove the bolt from the bottom of the rear quarter panel.
    3. Fig 1: Removing Push-In-Retainers & Bolt
    G01736729Courtesy of GENERAL MOTORS CORP.
  3. Heat the upper edge of the rear quarter panel molding to 21-32°C (70-90°F).
    • Keep the J 25070  at a distance of 152 mm (6 in) from the surface.
    • Use the J 25070  in a circular motion for 30 seconds.
  4. Use a J 41409  in order to strip the upper edge of the rear quarter panel molding from the surface.
  5. Remove the rear quarter panel molding from the vehicle.
    Fig 2: Removing Rear Quarter Panel Molding From Vehicle
    G01736730Courtesy of GENERAL MOTORS CORP.
  6. Remove all of the adhesive from the rear door body panel using 3M 07502  .
  7. Clean the rear door panel surface. Use naphtha, and allow the surface to air-dry.
scientia non olet · About LEMON Manuals