LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 567 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Body Side (Luxury - Y91) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
  1. In order to protect the body from scratches, use masking tape on the body side edge of the molding. The tape will also help in aligning the molding during installation.
    2. Fig 1: Applying Masking Tape On Body Side
    G01736726Courtesy of GENERAL MOTORS CORP.
  2. Heat the upper edge of the body side molding to 21-32°C (70-90°F).
    • Keep the J 25070  at a distance of 152 mm (6 in) from the surface.
    • Use the J 25070  in circulate motion for 30 seconds.
  3. In order to cut the adhesive material, use the J 41409  or a 0.8 mm (0.03 in) plastic line.
    Fig 2: Cutting Adhesive Material Using J 41409
    G01736727Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals