LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 567 (Exterior Trim) >> Repair Instructions >> Grille Molding Replacement - Lower >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the lower molding to the radiator grille.
    Fig 1: Installing Lower Molding To Radiator Grille
    G01736722Courtesy of GENERAL MOTORS CORP.
    CAUTION: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  2. Install the nuts (1) in order to retain the lower molding (2) to the radiator grille.

    Tighten 

    Tighten the nuts that retain the lower molding to the radiator grille to 1 N.m (9 in lbs).

  3. Install the radiator grill to the vehicle. Refer to Grille Replacement .
    Fig 2: Installing Nuts To Radiator Grille
    G01736723Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals